DKM Pulp Moulding System DKM 27-5B

Moulder M 27-5, Process P 27-5, Dryer D 27-5B

This is a turn key system.Training and installation videos on the moulder and process are provided as part of the cost. You connect the systems together as per instructions and turn on as per operating instructions. Installation assistance will be provided by Skype. On site assistance can be provided at an additional cost.
Estimated Delivery: 6 months from receipt of deposit for machine.
On site assembly: 0 weeks.

List of Equipment supplied with each DKM-27-5B

  1. Moulder M27-5 and process P27-5
  2. Single Source Pulping System
  3. DKM Dryer D 27-5B
  4. Dies

Moulder M27-5 and process P27-5

One face stainless steel moulding drum with quick die clamps suited for quick die change, anti- friction bearings (Platen size 686 mm x 413 mm).

  • Automatic die and decal wash system. This water is heated through a heat exchange system from the seal water in the vacuum pump.
  • Automatic transfer die oiling and cleaning system.
  • Manual and automatic operating settings.
  • One air receiver and one air puff receiver tank with inline filter, regulator and lubricators.
  • All necessary electrical controls and starters all wired to a control panel that can be run in automatic or manual.
  • One stainless steel moulding vat with a constant pulp flow system for product weight control, one 150 liters per minute pulp transfer pump 200 litre stainless steel circulation tank with automatic pulp level control from the pulpers.
  • One 230 psi die and decal wash pump.
  • One Travaini vacuum pump 15Kw – 11 cubic meters per minute.
  • One 39 litres per minute seal water pump.
  • One white water pump 150 litres per minute.
  • One 600 liter stainless steel vacuum tanks and one white water return Pumps @ 500 litres per minute.
  • Two heavy structural assembly frame epoxy coated.
  • Technical Services Supplied for installation and start-up.
  • Drawings
  • Assembly
  • Crating
  • Loading
  • Documentation
  • Jobsite Installation Materials
  • Spare Parts (limited supply)
  • All required electrical wiring (Note: the Buyer shall supply at its expense all the necessary electrical power including transformer as required by Seller for the Equipment as well as all cables up to the Seller’s control panels)

Single Source Pulping System

  • Two Pulper with 7.5Kw motor @ 400 liters @ 3.5% and 1200 liters @1.15%.
    Two pulpers supplying 45 Kg per hour Pulp is supplied on demand to the pulp circulation tank by gravity.
  • One 2,700 liter white water tank.

DKM Dryer D 27-5B

This is a batch dryer with three drying carts. (For 27” system):

  • One Natural gas or oil burners Total 500,000 btu’s.
  • One blower plug circulation fan. (185 cubic meters per minute)
  • One exhaust fan per zone.(18 cubic meters per minute)
  • Has a high temperature cut off and E stops
  • The dryer is complete with a user friendly main control panel.
  • The insulation is 10 cm rock wool fiber board. The panels are assembled to provide a sealed enclosure.


  • This machines comes with 2 dies.
  • Two Aluminum moulding dies and two UHMW with aluminum base transfer dies included.